Customizing a paco pad

custom Grand Canyon motor rig pads have closed cell foam, drain holes, and hinges

Motor Rig pads in action

In this drawing you can see a trapezoid shaped Paco Pad with some special features. I chose this old drawing, because it was not typical of our usual custom sizing and styling practice. Usually our custom Paco Pads are rectangular. Therefore all we would need to know is the length, thickness, and width. We also need to know if they are going to be rolled up, and if they need a valve. Valves are important to get pads small for shipping purposes. However many customers do not want valves on their pads.

This variation did need a drawing so we could specify the location of the loops that hold the straps in place. We also like to give customers a visual scale 3 dimensional drawing of what the product will look like with dimensions. In that way they can make sure that they are getting a workable product from us. If the product is complicated we would like you to read more about design collaboration. This service costs a bit more, but our customers very much like not having to send items back to have them manufactured a second time. We like it too.

I would like to say that cutting out a section where the wheel wells would be in a pick up truck is difficult and costly. We can do it, but we want you to know why we would quote a high price for such a thing.

Keep in mind that anything that is customized is going to take longer because it has to have special care going through the system. You should allow for 4 to 8 weeks for us to finish a customized product, and you should also expect to do some correspondence so we get it right.

Order inquiries: shop.jpwinc@gmail.com
Custom & Prototype inquiries: pschoser.jpwinc@gmail.com